Norteck 60 cm Digging Bucket for Mini Excavator

A perforated bottom, a smooth welded edge, and a 25 mm pin: the spec sheet for this Norteck 60 cm digging bucket reads like a checklist for drainage and finishing work. The bowl drains water without holding back sludge, while the rear edge leaves a clean profile after each pass. It mounts on compact carriers from 800 kg to 1.8 t, where a standard bucket carries too much material or lacks precision.

Mounting compatibility and fitting

The 25 mm pin connection follows the common pin spacing of mini excavators in this class. The 60 cm width covers agricultural ditches, gutters, and bank reclamation without excessive footprint. On Norteck SX10+, SX16, SX16-pro, and SX17 series, mounting is direct; the same applies to KUBOTA KX36-2, KX36-3, KX41-2, and JCB 801 models, provided you check the pin spacing and bushing diameter.

Bowl configuration

• Opening: 60 cm — suited for cleaning narrow trenches, manholes, and ditches.
• Perforated bottom — gravity drainage of water and fine material, reducing the suction effect in wet ground.
• Smooth welded edge — leveling in translation, without mounting an additional attachment.
• 25 mm pin — simple attachment; pins not supplied.

For wider operations or angled profiles, the Norteck 80 cm Digging Bucket increases the pass width without changing the pin size. If the coupler is equipped with a quick-hitch system, the Norteck Mini Excavator Quick Hitch reduces bucket changeover time on site.

Operating guidelines

The perforated bowl does not replace a screening bucket; it manages excess water and fine particles during digging. The carrier must stay within the 800 kg to 1.8 t range to maintain proper stability under load. The coupler pin spacing and pin diameter are the two check points before first use.